Rubber Stamps by Montarga

Eyelets

	Punch a hole in the desired position by stretching up the spring and releasing it. Have a cutting mat underneath your work.

	Push the eyelet through the hole from the front of the card. Turn the card over.

	Place the tapered end of the eyelet setter into the back of the eyelet. Pull up spring and release a couple of times until the eyelet spreads out. You may also hit the back of the eyelet with the flat part of the hammer to completely flatten the back of the eyelet (this is not always necessary).

	Tip: For mini eyelets: use a thick needle to make the hole.